Ford Ranger T7-T8 Wildtrak 2016 Onwards Bonnet Scoop

Description Ford Ranger ABS Hood Scoop & Bonnet Vent (T6, T7, T8 & Next-Gen) Aggressive Off-Road Styling | No-Drill Installation Give your Ford Ranger a dominant road presence with our premium ABS Hood Scoop. Engineered specifically for the T6, T7, and T8 (including Raptor and Wildtrak) models, this bonnet vent provides a wide-body, rugged aesthetic without the need for permanent vehicle modifications. Crafted from high-impact, UV-stabilised ABS plastic, it is built to withstand the toughest British weather conditions while maintaining its sleek matte black finish. Professional Installation Guide Follow these steps to ensure a factory-standard, permanent bond that stays secure at motorway speeds. 1. Pre-Installation Preparation Surface Temperature: For the 3M adhesive to activate, the bonnet must be between 15°C and 30°C. If installing in winter, use a hairdryer to gently warm the metal surface. Cold Engine: Ensure the vehicle has been stationary for at least 2 hours. A warm engine will cause the adhesive to “skin” too quickly, leading to a weak bond. 2. Decontamination (The Most Important Step) Clean & Degrease: Wash the area with soapy water, dry thoroughly, and then use Isopropyl Alcohol (IPA) or an alcohol-based wipe. Remove Wax: Most Rangers have wax or ceramic coatings. The tape will not stick to these. Ensure the surface is “squeaky clean.” 3. Dry Fitting & Alignment Marking: Before peeling the tape, place the scoop on the bonnet to find the centre point. Guides: Use low-tack masking tape to mark the edges of the scoop on your bonnet. This creates a “landing zone” for precise placement. 4. Final Application Peel & Stick: Remove the protective film from the pre-applied 3M automotive-grade tape. Activation: Align with your markers and press down firmly. Apply heavy pressure along the entire perimeter for 60 seconds to activate the pressure-sensitive adhesive. 5. Curing Phase The 24-Hour Rule: Do not wash your vehicle or drive at high speeds for 24 hours. Avoid rain exposure where possible during this initial curing period. Technical Specifications Feature Details Compatibility Ford Ranger T6, T7, T8 (2012–2022) & Next-Gen Models Material High-Impact, UV-Protected ABS Plastic Finish Stealth Matte Black (Paintable) Installation DIY “No-Drill” using 3M High-Bond Tape